Trouble Shooting Error On Your Printer

The problems surrounding the printer is a common problem and very frustrating for us. Of course this is very disrupting for computer users. Below are various problems in the printer and how to cope:

Printer can not live
this is caused by several things, among others "
1. Electric power cable not connected to the printer or not installed properly.
Immediately check the cable and plug it right back.
2. Electric power cable to break.
this is because for too long so that the cables used to be broken. To check wear tester.
3. Fuses on the printer end.
To see if the fuse on the printer is still intact or already broken open the printer and remove the fuse. If've seen broken, replace with new fuse.

Fuses life but can not print
The things that cause the printer can not print even though the printer is a flame is:

1. Or tape cartridge has not or is not installed properly. Check and correct kemblai pairs.
2. Paper not yet installed. To attach the paper to the printer can print.
3. Ink for printing is finished. Perform refill ink into the cartridge.
4. At the time of printing, you incorrectly entered the pages to print. Check to be sure that the page that you print is correct or wrong.

Printer prints but not until the end
Here are some things that cause your printer not to print out:
1. At the time of being printed, the printer ink run out.
To overcome this, immediately refill your printer ink.
2. At the time of printing was a sudden power failure.
3. At the time of printing you suddenly close the application program to be printed.
At perceatkan process, you do not close the application window being printed.

Printer print defects
Problem-the problem of this case are:
1. Truncated printouts.
This happens because the needle did not complete the knocker on the printer, or indeed because there is damage to the device driver. In another case the bias occurs because the cartridge is not normal.
For that check the relevant components are like the needle and cartridge knocker, or you can also make a head cleaning again and again.
2. Mold hopping.
This often happens in the dot matrix printer. The cause is not a smooth movement of print head due to dirty or clogged something.
To overcome this problem do the cleaning on the print head.
3. Ink spilled into the mold.
This is often the case, because the wrong cartridge cartridges atautinta the spill.
To overcome this problem, clean the ink is dry on the cartridge and attach it back to the printer.
4. Printer can not print pictures.
This is because the printer Properties less true.
Set up the printer properties correctly through Start / Settings / Control Panel / Printers.

In order for the printer can either keep the premises maintained and always clean the printer from dirt.